2026-11-18
Covering Y25 to Y160, a total of 10 case diameters. Select installation direction, case and connector material, accuracy, range and thread, system automatically assembles model code according to naming rules, and outputs pressure unit conversion results simultaneously.
Convert according to international unit standards and common engineering definitions (1 psi = 6894.757 Pa, 1 kgf/cm² = 98066.5 Pa, 1 mmHg = 133.3224 Pa, 1 inH₂O = 249.0889 Pa).
Gauge PressureTaking atmospheric pressure as zero, all pressure gauge readings are gauge pressure;Absolute PressureTaking absolute vacuum as zero, absolute pressure ≈ gauge pressure + 101.325 kPa.
Dual Scale: Inner scale bar, outer scale psi is a common practice, the "Range" on this page also provides MPa / psi conversion, which can be directly compared with the quotation and drawings.
kgf/cm²differs from bar by about 2%, these are two different units, not different ways of writing the same scale.
Values are all calculated from source values, no human rounding is done; engineering quotations and scale markings usually take 3-4 significant digits.
| Unit | Pa | kPa | MPa | bar | psi | kgf/cm² |
|---|
The bold "1" indicates that the unit in this row is itself. Water column units are calculated based on the density of pure water at 4°C, mercury columns are calculated based on the density of mercury at 0°C, consistent with common industry practices for instrument rows.
| Range (bar) | MPa | psi | kgf/cm² | kPa | Applicable Specification |
|---|
"Applicable Specification" automatically matches each specification range in the table; the range system of Y25 and Y30 is obviously smaller than medium and large specifications, and small specifications do not produce high-pressure ranges. This table is for accurate conversion values, and the dial scale marking follows the rounding rules in Section 04.
Letters are assembled in order, numbers are case diameter, separated by "-" in the middle.
Dry type and oil-filled shockproof are mutually exclusive.When selecting dry type, oil-filled or silicone oil cannot be selected; after selecting shockproof oil, dry type or iron case cannot be selected.
Iron case and oil-filled shockproof are mutually exclusive.Iron case (plated iron case) can only be dry type; oil-filled shockproof requires a stainless steel case.
Exclusivity comes from parameter table annotations:
"Select dry type, iron case cannot select shockproof oil, after selecting shockproof oil, dry type or iron case cannot be selected."
General engineering method: static pressure is the range of 1/3 ~ 3/4, pulse or impact pressure is reduced by one level.
After filling in "Actual Working Pressure", this page will display the range utilization rate and recommendations in real-time. Less than 30% indicates that the range is too large, wasting reading accuracy; more than 75% poses a risk of overpressure.
When selecting bar, keep the value in the table; when selecting MPa, take 1/10 of the original value; when selecting psi, take 14.5 times the original value and round it, keeping at most three significant digits, and append zeros at the end.
Example: 15 bar → 1.5 MPa → 218 psi (15 × 14.5 = 217.5, rounded to three significant digits is 218).
When "Custom Range / Nameplate" or "Custom LOGO" is selected as "Yes", the additional requirements must be filled in with at least 10 characters, otherwise the selection form cannot be reproduced.