2026-11-18
Covers Y25 to Y160, a total of 10 case diameters. Select installation direction, case and connector material, accuracy, scale and thread. The system automatically assembles the model code according to the naming rules, and simultaneously outputs the pressure unit conversion result.
Convert according to international unit standards and common engineering definitions (1 psi = 6894.757 Pa, 1 kgf/cm² = 98066.5 Pa, 1 mmHg = 133.3224 Pa, 1 inH₂O = 249.0889 Pa).
Gauge pressureTaking atmospheric pressure as zero, all pressure gauge readings are gauge pressure;Absolute pressureTaking absolute vacuum as zero, absolute pressure ≈ gauge pressure + 101.325 kPa.
Dual scale: Inner circle bar, outer circle psi is a common practice. The "Scale" on this page also provides conversions for MPa / psi, which can be directly compared with the quotation and drawings.
kgf/cm²differs from bar by about 2%, which are two different units and not the same scale writing methods.
Values are all converted from source values, and no human rounding is done; engineering quotations and scale markings usually take 3-4 significant digits.
| Unit | Pa | kPa | MPa | bar | psi | kgf/cm² |
|---|
Bold "1" indicates the unit of this row. Water column units are converted according to 4 °C pure water density, and mercury columns are converted according to 0 °C mercury density, which is consistent with industry common practices.
| Scale (bar) | MPa | psi | kgf/cm² | kPa | Applicable specification |
|---|
"Applicable Specification" automatically matches each specification scale sequence in the table; the scale system of Y25 and Y30 is significantly smaller than medium and large specifications, and small specifications do not produce high-pressure scales. This table is for accurate conversion values, and the dial scale markings follow the rounding rules in section 04.
Letters are assembled in order, numbers are case diameter, separated by "-" in the middle.
Dry type and shockproof oil are mutually exclusive.When selecting the dry type, glycerin oil or silicone oil cannot be selected; after selecting shockproof oil, the dry type cannot be selected back.
Iron case and shockproof oil are mutually exclusive.Iron case (painted iron case) can only be dry type; filled shockproof requires a stainless steel case.
Exclusions come from parameter table notes:
"Select dry type, iron case cannot select shockproof oil; after selecting shockproof oil, dry type or iron case cannot be selected".
General engineering method: static pressure scale is 1/3 ~ 3/4, dynamic or impact pressure is reduced by one level.After filling in "Actual working pressure", this page will give real-time scale utilization ratio and suggestions. Less than 30% indicates the scale is too large, and the reading accuracy is wasted; more than 75% has the risk of overpressure.Recommended range 30% – 75%
Dial value rounding
When "Custom Scale / Brand" or "Custom LOGO" is selected as "Yes", the additional requirements must be filled in with at least 10 characters, otherwise the selection sheet cannot be reproduced.
Anhui Xingyi Instrument Co., Ltd.
Data source: